Griswald

Eddie - is that the 950cfm throttle body?

Young Performance

No, that is the 2000 cfm throttle body. Holley also has a 1000 cfm that is on a 4150 flange. The 2000 is a 4500(dominator) flange.
Eddie

onesickpantera

iTrader: (1)

Eddie, I have the Holly 1000 cfm system on a 502 but using the MEFI system. The injectors are marked with a H-36.

Any idea on my hp limitation with this set-up?

freshwaterfiend

Thanks Eddie, that would be awesome. I'd know what I was dealing with ahead of time!

Young Performance

You will be limited by the injector size, not the throttle body. The formula is as follows:

Injector rating x # of injectors x injector duty cycle% / Brake Specifc Fuel Comsumption

In your case of the 36# injectors:

36 x 8 x .85 (85% is the average max.) / .5 (average NA BSFC) = 489.6 hp

You can certainly run a little more than 85% duty cycle. These figures are also at 3 Bar fuel pressure. You can run a higher fuel pressure to support more power as well. Your particular engine may also have a lower BSFC that will help. Bottom line, you have enough injector for about 550 hp. Any more than that will take larger injectors. However, the throttle body is large enough to support as much as you can make NA. Hope this helps.
Eddie