CONTEST:Guess my Engine Dyno HP & WIN an Engine Alignment Tool
 

Gellner Engineering is just about done building my engine and should be going on the dyno Tues (May, 11th).
I figured I would run a little contest(hope this works).
Throw out your peak HP number FIRST in your response(easier to go thru afterwards) or you will not be counted. I will take numbers till the results are in, one number each please.
Closest WITHOUT going over will win a new Bravo/Alpha engine Alignment Tool and I will pay for the shipping to(USA 48 states only). For a tie I have a fair tiebreaker idea if needed.

Hint: This engine build was just to put a reliable engine together and nothing crazy like some of you guys have.

Here is the engine stats:
547 CI stroker engine.
Naturally aspirated
10-1 Compression
World Merlin aluminum heads, bowls pocket ported.
850 Holley carb
Team G hi rise intake(no port matching)
Crane 741 cam Hydraulic roller/roller rockers lift Exh:632/Int:610
Stock thunderbolt ignition
Good Luck
My cheap plug= If anybody is looking for a Alignment tool or Gimbal bearing remover/installer or other tools Check me out on Ebay: whoya2350

625 hp @ 5500 rpm

650hp

What correction factor?:lolhit::lolhit::lolhit::lolhit::lolhit:

With or with out accessories?? :)

630 Hp @ 5500 Rpm

With seawater pump and I think he said with Alternator to.

Good one.:angry-smiley-038:

675hp @ around 5800

640hp