Originally Posted by SDFever
(Post 3154231)
Has anyone linked their Vessel View system to the windlass? In the beginning it was supposed to have anchor warning, scope measurment etc..
|
System view or Northstar are not now the only option - with Mercmonitor you can plug in any NMEA 2000 compliant GPS - in simple terms this means that all of the touchscreen Garmins will display the engine data on the screens - I doubt it will give you a slip reading, but it will give you all of the fluids levels and temps along with fuel to waypoint information.
Hope that is of interest? |
If anyone is interested I can convert old style motors to display this date. I have tested it a bit and it works very well.
Jon |
Originally Posted by Audiofn
(Post 3154908)
If anyone is interested I can convert old style motors to display this date. I have tested it a bit and it works very well.
Jon Comment: Seriously, I do not think this is possible can you explain how this is possible and projected cost. I have several friends that would love to have the Smartcraft/Vesselview unit on their respective older boats. KAP |
Originally Posted by Audiofn
(Post 3154908)
If anyone is interested I can convert old style motors to display this date. I have tested it a bit and it works very well.
Jon According to Mercury "All Mercruiser MPI (multi-port fuel-injected engines) Sterndrive, Inboard, and Tow Sports models with serial number 0M300000 and higher are compatible with SmartCraft instrumentation systems." As an example my 2004 350magMPI S/N:0M689xxx, can be converted, that is clear, but are you saying you can get SmartCraft to work on older motors? |
I have a Garming 4208. Is there a way to get the data to my Garmin?
I dont have any more dash space, can the Garmin be my monitor? |
1 Attachment(s)
I have a race edition and a 5212 in my active thunder and i hooked the garmin to the vesselveiw and it gives it the deep readings and gps speed. Its a awesome peice on equipment..
|
Originally Posted by TEAMBAJA
(Post 3154064)
I have both (Race View and Vessleview) that will be going in the Swap Shop soon if there is any interest. Both are new units from an employee sale a few years ago, but you will probably have to purchase the plugs/wiring for them. I'll check to see what I have.
Originally Posted by Keith Atlanta
(Post 3183906)
I have a Garming 4208. Is there a way to get the data to my Garmin?
I dont have any more dash space, can the Garmin be my monitor? |
Originally Posted by Single With Twins
(Post 3153436)
I have vesselview on my 2009 35 Fountain Lightning. I have not played with it too much but find valuable. stbd tach reads about 400rpm off but i just watch the screen and all is ok .......just need to figure out how to change the gauges........my bottom two are voltage and i would like something else obviously, have looked but can't switch them out.
It is great......... Jay |
1 Attachment(s)
The digital smart craft is what everything is tied too, as far as rpm limiters, and warnings. I would put more faith in that being accurate, than the analog gauges.
Be carefull scrolling through the pages that you dont activate this: |
All times are GMT -5. The time now is 12:23 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.