Teague Custom Marine 1335/1365 Engines Earn CARB Certification
#21
Registered
iTrader: (1)
What are the current regulations in Cali at the moment? Do new performance boat sales HAVE to include a CARB certified motor regardless the size? I was involved in this a few years back and at the time there were going to be exemptions for say engines over 500hp or so. Is that no longer the case?
#22
Banned
It's nice that it is rated for 2500 hp, but it is still only a single speed trans, what is needed is a multiple speed unit, and until then all you are going have to chose from is proping to small and being able to get up on plane and then bouncing of the rev limiter, or proping it for top end and barely being able to get on plane with passangers and a decent amount of fuel, until one is avilable in masses those six figure powerplants will never see there true potential.
Even the multispeed Weismann transmissions will handle the Teague motors.
#23
Offshoreonly Advertiser
Offshoreonly Advertiser
I was wondering what was going to happen to the independent builders, if you can understand it here is an interesting EPA doc
http://www.epa.gov/nonroad/marinesi-...8016-chp03.pdf
Tyson has done a great job on the 2 speed. As far as single speed transmissions go the VD looks good. We are adding them to our product line. I will have pricing and installation drawings soon. They are a bit longer than the 72 series currently in use, but it is the same unit for both driveline & plug in style which is nice! You either bolt a flange or an adapter plate on the back.
http://www.epa.gov/nonroad/marinesi-...8016-chp03.pdf
Tyson has done a great job on the 2 speed. As far as single speed transmissions go the VD looks good. We are adding them to our product line. I will have pricing and installation drawings soon. They are a bit longer than the 72 series currently in use, but it is the same unit for both driveline & plug in style which is nice! You either bolt a flange or an adapter plate on the back.
__________________
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
#24
Registered
I was wondering what was going to happen to the independent builders, if you can understand it here is an interesting EPA doc
http://www.epa.gov/nonroad/marinesi-...8016-chp03.pdf
http://www.epa.gov/nonroad/marinesi-...8016-chp03.pdf
What a nightmare. This means one thing for sure- prices are going up.
Interesting doc loaded with great info-
"Ilmor commented that they estimate that 80% of the High-Performance engines are produced by 5 or possibly 6 manufacturers. (Mercury, llmor, Teague, Sterling, Flagship, Chief). An additional 10-20 very small businesses, produce as little as 15-25 engines per year each."
If tohastu thinks they are going to be squeezed imagine the little guys.
UD
#25
Correspondent
Correspondent
Thread Starter
I've had a couple of questions via email on how long those transmissions would last at their maximum rating of 2,500 foot-pounds of torque. I am going to try to find an answer.
However, my best guess is ... not very long, just as an engine capable of producing that level of torque likely can't produce it for very long before it fails. But if a product is rated to handle a certain max output, and your highest output is well below that max, the product should last.
In other words, I suspect the transmission in question is overbuilt—a good thing in this case—for its intended use.
However, my best guess is ... not very long, just as an engine capable of producing that level of torque likely can't produce it for very long before it fails. But if a product is rated to handle a certain max output, and your highest output is well below that max, the product should last.
In other words, I suspect the transmission in question is overbuilt—a good thing in this case—for its intended use.
#26
#27
Registered
Join Date: Mar 2002
Location: Lake St. Clair
Posts: 2,975
Likes: 0
Received 0 Likes
on
0 Posts
Manufacturers specs.....
http://www.velvetdrive.com/Liberty72Brochure.pdf
http://www.velvetdrive.com/Liberty72Brochure.pdf
#28
Offshoreonly Advertiser
Offshoreonly Advertiser
Yes, 1500 ft lbs constant. The horsepower depends on the RPM,
HP = 1500 x RPM / 5252
HP = 1500 x RPM / 5252
__________________
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
#30
Registered