dyno pull!!!!!
09-10-2011 | 11:26 AM
#1
Thread Starter
Registered
Joined: Jun 2006
Posts: 764
Likes: 6
From: ILL
dyno pull!!!!!
Well so far super happy with my motor at Ateco!! They do it right the first time that is for sure!!Here is a nice pull on pump gas. 1100hp and over 1000TQ at 3500rpm!!!! I am in love hahahaha
Thank you Skydog
http://m.youtube.com/index?client=mv...?v=wm5EJGa4Hdg
Thank you Skydog
http://m.youtube.com/index?client=mv...?v=wm5EJGa4Hdg
Last edited by skydog; 09-10-2011 at 11:29 AM.
09-10-2011 | 12:35 PM
#3
Thread Starter
Registered
Joined: Jun 2006
Posts: 764
Likes: 6
From: ILL
09-10-2011 | 01:24 PM
#5
Registered
Joined: Jan 2001
Posts: 175
Likes: 0
From: Long Island, NY
09-11-2011 | 10:11 AM
#9
Registered
Joined: Mar 2009
Posts: 116
Likes: 0
Skydog,
I would not think they needed to do to much to get that hp with your current set up.
Did they just add more boost to get the additional hp or did they have to change cam and work carbs also.
Nice boat and motor.
Joel
I would not think they needed to do to much to get that hp with your current set up.
Did they just add more boost to get the additional hp or did they have to change cam and work carbs also.
Nice boat and motor.
Joel
09-11-2011 | 10:29 AM
#10
Thread Starter
Registered
Joined: Jun 2006
Posts: 764
Likes: 6
From: ILL
Thank u guys!!! Yea we added about 150hp and about 200tq at same boost level and less timming
Solid roller cam,lifters,springs,shaft rockers,innercooler,and added some bigger jets.
Again thank u guys can not wait I can now spin more Rpms too with shaft rockers. Sure hope for a vid of 130-135mph should be there.
Skydog
Solid roller cam,lifters,springs,shaft rockers,innercooler,and added some bigger jets. Again thank u guys can not wait I can now spin more Rpms too with shaft rockers. Sure hope for a vid of 130-135mph should be there.
Skydog
