BillR

I need a nice looking glove box for my center console. I need a screw in - complete unit; not just a door.
I don't want it to look like it belongs on a fish boat. Would love one that can be powder coated to look like some of the Eddie Marine offerings.

Here is pic of console - want it to go to the right.

damdonzi

Dana Marine seems to have a few:

http://www.danamarineproducts.com/se...c-9e7d70b091a4

Wild

i was looking for two glove boxes for speedy and could only find the covers also, i had to get mine from MTI then get the covers

BillR

Those are doors only - but that is the look I would prefer!

Plum_Crazy

I went through this search with my last boat. I ended up using a DMP door and had my local metal fabricator build a box out of aluminum. I lined the inside with black bedliner to keep things from sliding around.

damdonzi

My mistake. I agree. Like the look as well. Maybe a couple of things below:

http://www.ssicustomplastics.com/everything.htm

http://www.deepbluemarine.com/produc...?CategoryID=22

http://www.boatoutfitters.com/boat-glove-boxes.html

http://www.firstchoicemarine.com/c-118-glove-boxes.aspx

https://www.whitworths.com.au/main_i...AbsolutePage=1

TCBoss302

iTrader: (3)

I haven't installed mine yet, but what I did was buy a complete glove box from Overton's and bought a nice billet door from Dana Marine. I took the crappy plastic door off the unit from Overton's, and I'm going to mount the box to the back side of my dash panel and then the billet door to the outside. I think it will look nice, I'll post a pic to this thread when I get it done. Hope this helps.

Revd Up

I too had this problem with my old boat. Couldn't find anything. Take some good measurements and make up a drawing of what you would like it to look like. Then take it to a plastics shop and have them make it up. Once I got it back, I finished cutting the hole to match perfect, installed it, and then painted the dash to match the graphics on the boat. Here's how it turned out.

northernoffshore

ebay