Offshoreonly.com - So, it's 80*, not a cloud in the sky, vero % humidity....

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Boating Discussion (https://www.offshoreonly.com/forums/general-boating-discussion-51/)

- - So, it's 80*, not a cloud in the sky, vero % humidity.... (https://www.offshoreonly.com/forums/general-boating-discussion/290697-so-its-80%2A-not-cloud-sky-vero-%25-humidity.html)

no its the bottom where the roller bearing should be that rides on the cam where it is, is yet to be determined along with the rest of the missing peaces

Quote:

Originally Posted by 1989mach1 (Post 3859348)

no its the bottom where the roller bearing should be that rides on the cam where it is, is yet to be determined along with the rest of the missing peaces

what I meant. Being upside down in your picture, it's on the top :helmet:

Just picked my block up and am ready to clean parts and re-assemble. Have $350. in one piston, 1 ring set, 1 sleeve, bore that sleeve to + .020", hone the other 5, weld the hole in the front half and one crack at the bottom of a rod slot.
Not bad :whistle:
Realized on the way there I screwed up too. I had used standard bore sleeves in my shop and being in a rental house, I could have thrown the block in the oven, stunk out the house and replaced my own sleeve as I've done before.
Would have had $100. in the whole deal. Doh :helmet:

its gota be nice doing all your own work. cant wate till im to that point with my new boat. will save so much cash. r u going to make the trip up this summer? or still trying to work it out

We'll see.......

Quote:

Originally Posted by 1989mach1 (Post 3860925)

r u going to make the trip up this summer? or still trying to work it out

still studying logistics. Also, just started a new job so 2 wks off may be a bit of a push :whistle:

hope u can make it happen. i will get ya a beer at kelleys if u make it up :ernaehrung004: