I have seen where they relieved the back side of the thrust tube a bit to allow for heavy reentry. Doesn't look like it here though... is it neccesary?

While running at speed the thruster will be out of the water and should not change any performance characteristics of the bottom. The front of each thruster tube will have a flare built into it, this will redirect the water when it hits the bow and stop water from eating the back of the tube.

Please call Alan today for a quote to this, similar or other service projects.

Alan Gordon
Service Manager - Pier 57
847-336-9037
[email protected]

Some progress and steps towards completion. Once again the final piece will have a flare at the front of the thruster tube to prevent water from hitting the rear of the thruster tube. This will result in a smoother / quiter ride.

Please call Alan today for a quote to this, similar or other service projects.

Alan Gordon
Service Manager - Pier 57
847-336-9037
[email protected]

Here is the final outcome and fitment. Looks just like a factory install.


Please call Alan today for a quote to this, similar or other service projects.

Alan Gordon
Service Manager - Pier 57
847-336-9037
[email protected]

nice job! look OEM!

What's the average cost of installation?

Good question

Any results in performance? How did the tubes hold up?

Do you offer different pitch impellers for faster docking performance?

dam I hate to see holes cut in fiberglass......but you gotta do what ya gotta do.in my case when I cut holes in f-glass.messure 6times,,,,or more.then cut hole.chit gives me the willeys.lol