There is a 6" access plate for the hatch pin so it needs to be removable. Planning on alum. railing like canvas mounted to an arch. (no velcro)

XT

Yes, but could you email me any photos to compare? xt@xt-innovationsDOTcom

sent email, please let me know if you didn't receive it.

Sunday Mom's day! so a chance to post some updates.

Making the final skin patterns for cockpit interior, cabin ceiling almost done, strip lighting in the ceiling now, and making room for the 19" flatscreen TV that will be mounted in a reinforced box to support it for Lake Michigan, or any rough water.

Early rendering for rear seating design. Many improvements made.

XT

I like it!

Question, the bolster on the passenger side, the switch looks like it is almost touching the fiberglass. Is that just an illusion from the camera angle?

No illusions, just using the drivers side bolster to check the fit on the passenger side, thats all. Good catch though!

XT

Some of these photos are pretty boring, but it is all part of the process of getting it done.

The electric bolsters look like they belong in the next Terminator movie....lol

XT

Those seats look ready to start walking. I love the bulkhead with the flatscreen built in.

Had to make a fixture to trim the cuddy seating that was curved in place. New refrigerator arrived and getting the rear seat in place now. Going to combine the ship to shore radio and stereo in the sane frame this time.

XT

Wow, I can't wait to see her.