Offshoreonly.com - Help with BPM V12 engines

Page 2 of 3

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Boating Discussion (https://www.offshoreonly.com/forums/general-boating-discussion-51/)

- - Help with BPM V12 engines (https://www.offshoreonly.com/forums/general-boating-discussion/330234-help-bpm-v12-engines.html)

innerrage

08-29-2015 02:59 PM

would about a cris craft website site they run them old v12 engines or call diesel power in the u.k the sell bpm parts on their website tel 44 0 2086480041

RMPRam

08-29-2015 09:14 PM

Quote:

Originally Posted by 14 apache (Post 4348767)

Think cometic will make any gasket you need if you have a sample.

I called them and they wanted $5000 to set up the tooling to do head gaskets as they do not mfg. a head gasket for this engine. To rich for me.

RMPRam

08-29-2015 09:16 PM

Quote:

Originally Posted by bor (Post 4348730)

shoot me a email at [email protected] whit the parts you need and the details of the engines like serie #

and I see what I can do for you

It is a 620SH (750hp) and the serial # is 4867

RMPRam

08-29-2015 09:27 PM

Quote:

Originally Posted by innerrage (Post 4348782)

would about a cris craft website site they run them old v12 engines or call diesel power in the u.k the sell bpm parts on their website tel 44 0 2086480041

Do you have a e-mail for them? Or a complete address so I can look them up on the web?

BROWNIE

08-30-2015 05:44 AM

Engineer Pasti runs the place. They are first class. Call them on September 1 and you will have no problems.

hallj

08-30-2015 10:03 AM

I'll bet you worked on a few Magnum projects powered by those! I'm off to Cowes next week.
I'll say hi to Sonny Levi for you.

Jeff

RMPRam

08-30-2015 10:37 AM

Quote:

Originally Posted by BROWNIE (Post 4348935)

Engineer Pasti runs the place. They are first class. Call them on September 1 and you will have no problems.

Thanks Brownie, I will.

14 apache

08-30-2015 12:09 PM

Quote:

Originally Posted by RMPRam (Post 4348880)

I called them and they wanted $5000 to set up the tooling to do head gaskets as they do not mfg. a head gasket for this engine. To rich for me.

WOW that's rich

RMPRam

08-30-2015 02:24 PM

Quote:

Originally Posted by 14 apache (Post 4349066)

WOW that's rich

That's what I thought. There probably isn't enough of their V12's out there to make it worthwhile for them to gear up for a small production run.

Wally

08-31-2015 09:50 AM

If you cant get a hold of the factory, try these guys : https://www.flatoutgroup.com/
They make custom gaskets...had some custom stuff done for me that was VERY reasonable... just found them by chance...owners name is Mark..

All times are GMT -5. The time now is 06:59 PM.

Page 2 of 3

Show 40 post(s) from this thread on one page