picture of my cat
#12
Registered
Thread Starter
KAtdrvr, I forgot to check the tunnel . It was a little bumpy riding so I would say probably a center pod model !
Cord , I almost had a worse reck then Cousin tracy ! I got cought on the steering wheel !
The extra parts in the back make for a quicker fix ! You don't have to go find them under the seat ! See thats where skater will never compare .THey don't put a parts holder on the back !!
As for the PFD, it was overloaded with me ! (The little one ) If I added another pound it would sink for sure !
Too OLd , I cut the mounting lip off the scoops . the scoops where mounted by cutting a 1/4" deep X 3/8" wide slot around where the scoops contacted the hatches . MAde sure the scoop covered it all with the excess of the slot being to the under side of the scoop . Poured some super strong epoxy in the slot and set the scoop in it . NIce neat fit ! Also put a couple small strips off fiber glass under it for saftey straps ,just in case . Took a little time to cut it exact but it was well worth the time !
Audio , A couple "DAYS" left ? I need more then that !!
Kaamacat, It's all of 12' wide !! Well ,like 11'11" ........ It's a whole lot of boat ! I love it though Or were you talking about the little one ??? I think that is about 2 1/2' !
Cord , I almost had a worse reck then Cousin tracy ! I got cought on the steering wheel !
The extra parts in the back make for a quicker fix ! You don't have to go find them under the seat ! See thats where skater will never compare .THey don't put a parts holder on the back !!
As for the PFD, it was overloaded with me ! (The little one ) If I added another pound it would sink for sure !
Too OLd , I cut the mounting lip off the scoops . the scoops where mounted by cutting a 1/4" deep X 3/8" wide slot around where the scoops contacted the hatches . MAde sure the scoop covered it all with the excess of the slot being to the under side of the scoop . Poured some super strong epoxy in the slot and set the scoop in it . NIce neat fit ! Also put a couple small strips off fiber glass under it for saftey straps ,just in case . Took a little time to cut it exact but it was well worth the time !
Audio , A couple "DAYS" left ? I need more then that !!
Kaamacat, It's all of 12' wide !! Well ,like 11'11" ........ It's a whole lot of boat ! I love it though Or were you talking about the little one ??? I think that is about 2 1/2' !
#15
Registered
Thread Starter
The worst part of the little one is the people walking by are as bad as jet skies ! They walk right in front of you just when you get it going it's fastest !
Last edited by boot; 09-16-2002 at 05:47 PM.
#17
Registered
Thread Starter
Too Old , NO I didn't think to take step by steps . I could take some close ups and post them . I think you could figure it out very easy from that . And I could give you more details if needed .
#20
Registered
Thread Starter
TooOLD , I'll get some for you .
Timicin , YOu got that right !
Luke, Do you know Paul the former owner or Jerry the mechanic ? I would love to hear about what you know . IF you like e-mail me the good the bad and the ugly at : [email protected]
Thanks alot ,JOE
Timicin , YOu got that right !
Luke, Do you know Paul the former owner or Jerry the mechanic ? I would love to hear about what you know . IF you like e-mail me the good the bad and the ugly at : [email protected]
Thanks alot ,JOE