Need Some Dyno test results for 496
#52
https://www.pepboys.com/product/details/9769746/00715
NLA and NLA at all the auto parts store. Been there and done it and have the T shirt for it.
Maybe can find something on an old shelf sitting around new in the package or left over online but you will have to have some luck and time involved.
And if you love google.
BWD is not a Borg Warner Division - they sold that end a long time ago. The quality is not the best to say the least. I would rate as average
NLA and NLA at all the auto parts store. Been there and done it and have the T shirt for it.
Maybe can find something on an old shelf sitting around new in the package or left over online but you will have to have some luck and time involved.
And if you love google.
BWD is not a Borg Warner Division - they sold that end a long time ago. The quality is not the best to say the least. I would rate as average
Last edited by BUP; 03-13-2016 at 01:42 PM.
#54
Registered
[QUOTE=BUP;4414536]BAM has it in their notes CORRECTLY under your engine serial number
I was going off of this where the cutoff is OM687082 --> http://www.mercruiserparts.com/bam/s.../6272/6708/110
I don't remember 2 sensors being listed last time I looked this stuff up over a year ago. I could have sworn it just showed the NLA sensor. Then again, I could have had my head up my butt like I often do. Looking at the notes on the sensor that is still available I now see where my serial number falls under the sensor that is available.
I was going off of this where the cutoff is OM687082 --> http://www.mercruiserparts.com/bam/s.../6272/6708/110
I don't remember 2 sensors being listed last time I looked this stuff up over a year ago. I could have sworn it just showed the NLA sensor. Then again, I could have had my head up my butt like I often do. Looking at the notes on the sensor that is still available I now see where my serial number falls under the sensor that is available.
Last edited by Knot 4 Me; 03-15-2016 at 08:10 AM.
#56
Gold Member
Gold Member
The torque on the Mag is around 500 ft lbs at 3000 rpm.
#58
Gold Member
Gold Member
I dont know where theres a stock dyno sheet. Google "Dana Marine 496 Mag/HO". There is a lot of data on the internet with dyno sheets. Just subtract 15 HP/TQ
It will at least get you close and see the approximate curve.
It will at least get you close and see the approximate curve.
#59
stock results vs SC results --- click on dyno results on the page from link - shows max tq 500 at 3800 rpms -
https://whipplesuperchargers.com/ind...product_id=149
https://whipplesuperchargers.com/ind...product_id=149
Last edited by BUP; 10-23-2016 at 12:14 PM.