|
Originally Posted by Baja Rooster
(Post 4650242)
Im embarrassed to admit that I had put the intake hose on the wrong nipple of the pump and it ran fine on the hose spitting water out of the exhaust. It wasn’t until I got to the lake and it wasn’t drawing water did I notice the mistake. |
Originally Posted by outonsafari
(Post 4650584)
On a 100 foot hose, 3/4 i.d., and the earmuffs modified with dual 5/8 i.d. hose, 5/8 i.d. fittings and the Y pipe gutted out.
I get 5 gallons a minute, and 5 gallons a minute w/o the earmuffs. Question would be is 5 gallons enough for idle to flush engine w/o hurting the seapump? Only mod left would be to cut the hose down to 30 feet and run the boat next to the house rather than in its parking place. Thanks https://cimg3.ibsrv.net/gimg/www.off...27232391b9.jpg I dont see shortening the hose doing much...X amount of water goes in to the hose, X amount has to come out the other side, whether its 3 feet or 300.... |
Not 100 % sure but doesn't the power steering shaft have an Allen head recess in it ? If so you can just loosen the belt and and spin it without taking the pulley off. Makes that part a little simpler at least.
|
| All times are GMT -5. The time now is 01:08 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.