New Marine Mat carpets have arrived....
#1
Gold Member
Gold Member
Thread Starter
New Marine Mat carpets have arrived....
Worked with Tony at Xtreme Marine on these. Just pulled from box so they are still wavy but a great upgrade!! Problem is it makes other things look dated now - a never ending cycle I'm sure....
Had a carpet made for the Donzi 16 as well.....
Had a carpet made for the Donzi 16 as well.....
The following users liked this post:
thisistank (06-10-2020)
#3
Gold Member
Gold Member
Thread Starter
They offer peel and stick, and snap-in. I'm kind of doing a combination, but the tiger is so deep that I'm not sure I'm even going to connect that, I might just lay it in.....
#4
VIP Member
VIP Member
I also purchased similar to what you have and chose to lay it in without snaps. At any decent speed it would start to flop around under the seats. I went with industrial strength super velcro, available at Lowes, it has waterproof adhesive and problem solved without installing snaps.
#5
Gold Member
Gold Member
Thread Starter
I also purchased similar to what you have and chose to lay it in without snaps. At any decent speed it would start to flop around under the seats. I went with industrial strength super velcro, available at Lowes, it has waterproof adhesive and problem solved without installing snaps.
Will install snaps on the foot rests though......
The following users liked this post:
VoodooRob (06-09-2020)
#7
Registered
iTrader: (1)
Where`s this Tony out of? (google finds a lot of Extreme marine places from Ohio to florida , seems like a popular name lol)
I had send Marine Mat a detailed diagram and all the measurements needed to make a one piece snap in carpet and theysaid I would have to send the entire crapet in.. umm pass.
How did all their get measured out? Tony do it?
Looks great btw.
I had send Marine Mat a detailed diagram and all the measurements needed to make a one piece snap in carpet and theysaid I would have to send the entire crapet in.. umm pass.
How did all their get measured out? Tony do it?
Looks great btw.
Last edited by ICDEDPPL; 06-09-2020 at 09:50 AM.
#8
Gold Member
Gold Member
Thread Starter
I shipped him my original carpet and he made a first pass at it. We then worked details (he sent a couple mylar templates) until we got it right. Since I was so far away we actually FaceTimed a couple times to talk through some of the adjustments - 1/4" here, 1/4" there.
What's funny is just sending the carpet in would never get it good enough from afar in my mind
The following users liked this post:
ICDEDPPL (06-09-2020)
#10
Gold Member
Gold Member
Thread Starter
No, but I didn't look very far. A couple people recommended Tony and he had the ability and familiarity with the Cig logos to make those happen so I just started working with him