Keith Eickert still in business for parts?
 

Need a new body for one of his raw water pumps. Phone # on website goes to voicemail, no part numbers or prices on website. Plus didn't he sell his business / name at one time then start over again? Any contact info would be helpful. Thanks.

Did you try this one ?
https://keautoandmarine.com/

Yes. That's the site I got the phone # from. I found a pump that looks like mine but it's not a great pic. It's a fla number and I thought he relocated in the midwest somewhere

Yes, with Onken years ago. I thought that folded too ? Maybe not ?
https://www.lakeexpo.com/news/lake_n...a4bcf887a.html

Lightning Performance Group
Easton, Illinois
309.562.7474

the pumps that Harden and CP Performance sell are the same pump I far as I know I used there body's to replace some old nylon pump body's that were on some old Eickert class one motors they worked great. Regards Dan

PM'd

If its this pump in the pic and the housing and shaft are good you can rebuild the pump with new bearings and seals. I ran these pumps on my skater and i use to rebuild them when the bearings went bad. Bearing #6204RS Seal# 20.32.8 you can get them from Buffalo Bearing. If the housing is cracked or beat up you can get the new housing its a new design i ordered one awhile back.
https://cimg8.ibsrv.net/gimg/www.off...1c1b8869c.jpeg

that's the pump. It sucked something in and there is plastic melted onto grey housing. Doesn't really want to come off and I know I'll gouge it up pretty good if I can remove it at all. I was looking to replace just the pump body.

I'll take a look. The pump is the one pictured above. Not sure how old that model is but it came directly from Keith a few years ago as a new pump. Is that the one you were thinking of Dan?

Did you call peterson? They sell the parts for Keith 512-296-3434 Last time i bought the housing it comes with the new shaft because its a new design.