what is your boat most in need of?
06-28-2022 | 07:06 PM
#32
Gold Member
Joined: Jun 2006
Posts: 5,122
Likes: 967
From: Seaford, VA
Lost reverse last weekend.
If I’m doing one cable might as well do both, and the bellows and both gimbal bearings. Oh and I was lucky enough to break off the dumbass plastic fitting that goes through the assembly for the drive lube. Whoever designed that should be shot.
Hope to be back in water this weekend assuming no hiccups.
If I’m doing one cable might as well do both, and the bellows and both gimbal bearings. Oh and I was lucky enough to break off the dumbass plastic fitting that goes through the assembly for the drive lube. Whoever designed that should be shot.
Hope to be back in water this weekend assuming no hiccups.
06-29-2022 | 01:43 PM
#35
Driver-441
Joined: Aug 2004
Posts: 12,013
Likes: 1,515
From: Lake George
Lost reverse last weekend.
If I’m doing one cable might as well do both, and the bellows and both gimbal bearings. Oh and I was lucky enough to break off the dumbass plastic fitting that goes through the assembly for the drive lube. Whoever designed that should be shot.
Hope to be back in water this weekend assuming no hiccups.
If I’m doing one cable might as well do both, and the bellows and both gimbal bearings. Oh and I was lucky enough to break off the dumbass plastic fitting that goes through the assembly for the drive lube. Whoever designed that should be shot.
Hope to be back in water this weekend assuming no hiccups.
08-12-2022 | 01:11 PM
#37
Registered
Joined: Feb 2012
Posts: 1,131
Likes: 1,287
From: Sarasota FL. Priest River ID
ITS xr input shafts. Most likely two of them. They didn’t get along with the drive guardian couplers.
Merc says mid September. Was all set for the Catalina run in September but not lookin so good now.
Merc says mid September. Was all set for the Catalina run in September but not lookin so good now.
