I think I will get the red silicon Icdedppl. It will match my push buttons
https://cimg8.ibsrv.net/gimg/www.off...ed3a0c7151.jpg

Sweet ride and tunnel ram , my man !:ernaehrung004::D
Ive tried black but it doesnt hold up to the heat .
pics per request.



https://cimg9.ibsrv.net/gimg/www.off...300d13a3c1.jpg



https://cimg1.ibsrv.net/gimg/www.off...0978d85371.jpg

We will see. I just ordered them and they will be here fri. Now i just need to bend the trim rings in my press so they lip over the transom...fun times..

Sweat Ride, like dead people said no on the inner tube. I would assume your pipes are dry but water in them? We normally have a small hole at the bottom ends just to bleed a little out so they don't get extremely hot.

On bending the trim rings, I had to shear mine to clear the swim, could you do that on the bottom side?

EDIT: Never mind took a closer look at the picture, wow you are right at the bend.

Looks VERY nice
Congrats !!

Update
 

Thanks for the info dead plps.
https://cimg1.ibsrv.net/gimg/www.off...d3fd432ed3.jpg
https://cimg2.ibsrv.net/gimg/www.off...4fc2b70af6.jpg
https://cimg3.ibsrv.net/gimg/www.off...d3fbaf1b5a.jpg

Perfect .

What's the trick for installing the gasket material?

I installed the ones I bought from Teague with the rings as they came. Used Dawn dish soap to help them slide on.

1 week later, and they're split in 2 or 3 different spots.

4" OD exhaust pipes.

5" Trim rings.

These exhaust gaskets. https://teaguecustommarine.com/trans...ust-seal-black


https://cimg9.ibsrv.net/gimg/www.off...d0f7294f25.jpg
https://cimg0.ibsrv.net/gimg/www.off...6c9f411a66.jpg
https://cimg1.ibsrv.net/gimg/www.off...2aad04bdd5.jpg

Heard back from Teague. They are sending me new gaskets/transom seals. Said they should not have cracked and there should be no need to trim them. Just install them as is.

Got to say, Teague is very responsive when I have reached out to them. So far it's always been the next business day.

Good to hear I'll be putting some on in a couple weeks.