Winter Project Boat: I bought an Apache
Norty going ALL IN !
05-14-2011 | 01:46 PM
#154
Thread Starter
Registered
Joined: Dec 2000
Posts: 12,746
Likes: 0
From: Bell Canyon, CA
We may have no choice.......but we'll give selling it a try! 
Ready by Memorial......gonna be VERY tight. 
Progress shots from yesterday. Lots of little details coming together.....like I had some new stainless plates made to replace the old plastic ones.
Ready by Memorial......gonna be VERY tight. Progress shots from yesterday. Lots of little details coming together.....like I had some new stainless plates made to replace the old plastic ones.
05-22-2011 | 10:46 PM
#157
Thread Starter
Registered
Joined: Dec 2000
Posts: 12,746
Likes: 0
From: Bell Canyon, CA
Thanks Tanks.....it's all new and will last longer than me now. It still has to be sanded. New engines are in, getting rigged. New Gibson bullet tips for all six noise makers. Final (for now) gel and paint are being done. New engine insulation and noise foam. Then comes the dash and new in-n-out electronics!!!!!!!!!!!!!!!!!!
Last edited by PhantomChaos; 05-22-2011 at 10:48 PM.
05-23-2011 | 06:33 PM
#159
Registered
Joined: Aug 2001
Posts: 14,569
Likes: 4,534
From: Channel Islands, So. Cal.
Thanks Tanks.....it's all new and will last longer than me now. It still has to be sanded. New engines are in, getting rigged. New Gibson bullet tips for all six noise makers. Final (for now) gel and paint are being done. New engine insulation and noise foam. Then comes the dash and new in-n-out electronics!!!!!!!!!!!!!!!!!!
It's been too long since I"ve been drunk on that boat....Get that thing in the water!!
05-23-2011 | 07:25 PM
#160
Thread Starter
Registered
Joined: Dec 2000
Posts: 12,746
Likes: 0
From: Bell Canyon, CA
