|
Originally posted by Troutly We kinda strayed a weeeeeeee bit off topic :p |
Hey Scott
I knew you were joking, hell you and I can't afford that Amsoil stuff anyway! Sandisk: Thought I would bring you up to date the GM HP3 engines that were annouced to be available by GMC and GM High Performance have been pulled from the catalogs and are not available do to technical difficulties. The difficulty is rumored to be that GM High Performance could not get them to make 525HP so they cancelled the offering. Thats one of the reasons we have been developing so much lately to get the output of these motors up over the real 500HP plus level normally aspirated! The only things holding these engines back are the stock iron heads(great boat anchors) and the factory intake manifold. In a few months this summer a few 496's will be turning heads as they buzz past a few 500HP and 525HP powered boats! Would somebody please take care of Wasabes hot box!! Raylar;) ;) ;) :D |
I agree, alum heads done right, cam, beef up the air/fuel CFM and look out. If you mill the heads can you increase the compression ratio too? 500+ HP?
Darn tootin! |
Originally posted by Madmax Well, guys, not to burst any bubbles, but I have a 2001 hp500efi on the stand right now, and there's nothing but GM in there as far as the short block goes......... JE pistons, GM crank, 7/16" rods...... nothing you can't order right out of the GM performance parts catalog. The oil pump pickup is welded tho as somebody said on here. not that GM doesn't know how to build a motor tho..:D |
Originally posted by Raylar the GM HP3 engines that were annouced to be available by GMC and GM High Performance have been pulled from the catalogs and are not available do to technical difficulties. The difficulty is rumored to be that GM High Performance could not get them to make 525HP so they cancelled the offering. "The difficulty is rumored..." |
why do you all use GM crate motors? The money spent when completed is the same if not more than custom built with wonderful torque curves per application.and usually higher RPM.Start with Keith Black blocks GM spin off. Just a question.
|
This has been quite the interesting thread. I honestly feel most everyone who participated in this thread felt they were offering facts, and no one was intentionally trying to offer wrong information. But I do feel this shows that what is advertised in boating circles may not always be exactly what you get in reality.
Such as, I agree that Mercury Racing always gave the impression, if not actually claimed that the HP500 series motors were all hand built from carb to pan. Obviously it was. Just not by Mercury Racing, as they would have us believe. I remember when they used to advertise a 3 angle valve job on everything that went out painted blue. After seeing some of the HP500 valves, I question that too, as well as a lot of other stuff. I hope there are no hard feelings following this thread as I respect everyone who weighed in with catalog and website info, factory info, exectutive and technician "word-of-mouth" info as well as actual/visual part verification. Let's face it gentlemen, GM makes really good stuff, no matter how big or new it is. Mercury is really good at marinizing GMs' stuff. Mercury Racing has some beautiful blue paint and cool valve cover decals. |
Agreed. More mis-information here than fact. About a 20/80 ratio.
|
Originally posted by Gordo I agree that Mercury Racing always gave the impression, if not actually claimed that the HP500 series motors were all hand built from carb to pan. Obviously it was. Just not by Mercury Racing, as they would have us believe. I remember when they used to advertise a 3 angle valve job on everything that went out painted blue. After seeing some of the HP500 valves, I question that too, as well as a lot of other stuff. |
| All times are GMT -5. The time now is 11:34 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.