Well, Cord and I are back from Maine!
#21
Platinum Member
Platinum Member
Join Date: Jun 2001
Location: Silverdale,Washington,USA
Posts: 602
Received 0 Likes
on
0 Posts
Re: Well, Cord and I are back from Maine!
Cord,
More than likely it's the oil cooler, you need to pull the filter and the filter mount which is the cover of the oil cooler, there is a gasket and then the oil cooler element, factory manual says you can test the element by applying 70 PSI air pressure to check for leaks, if you install a new cooler don't forget to remove the shipping plugs before installing and then tighten the cover bolts back to 18 ft/lbs, to pull the cover off you will need to remove the turbocharger oil supply line, when reinstalling it torques to 11 ft/lbs.
Might want to flush the cooling system also
Good luck,
Caleb
More than likely it's the oil cooler, you need to pull the filter and the filter mount which is the cover of the oil cooler, there is a gasket and then the oil cooler element, factory manual says you can test the element by applying 70 PSI air pressure to check for leaks, if you install a new cooler don't forget to remove the shipping plugs before installing and then tighten the cover bolts back to 18 ft/lbs, to pull the cover off you will need to remove the turbocharger oil supply line, when reinstalling it torques to 11 ft/lbs.
Might want to flush the cooling system also
Good luck,
Caleb
Thread
Thread Starter
Forum
Replies
Last Post
Waterfoul
General Boating Discussion
25
10-03-2004 06:45 AM