where are the active thunder guys
11-30-2004 | 09:51 PM
#31
Registered
Joined: Dec 2003
Posts: 1,113
Likes: 0
From: Slidell,La
Re: where are the active thunder guys
no i dont but it is really simple to build. we just made a receiver cup for the pole to fit in
& welded it to a plate that gets thru bolted to the the floor area that extends into the engine compartment. it's alot easier if you have twin hatches that open in the middle like my older cig. i just trimmed the hatches under the vinlyl & you can't tell when the poles not up.
& welded it to a plate that gets thru bolted to the the floor area that extends into the engine compartment. it's alot easier if you have twin hatches that open in the middle like my older cig. i just trimmed the hatches under the vinlyl & you can't tell when the poles not up.
Last edited by vette131; 11-30-2004 at 09:54 PM.
12-01-2004 | 01:47 AM
#35
Charter Member #94
Joined: Oct 2000
Posts: 2,694
Likes: 5
From: Sunrise Beach MO
Re: where are the active thunder guys
Originally Posted by ActiveThunder
...And don't even touch the length of time it takes me to return phone calls.....
I realize most of this smack has been all in fun, but after reading some of the lip service from some of these guys, I wouldn't be afraid to put the lil ole 25 Thunder up against some of your so called "big dawgs" out there. And I'll even leave the padded hatch on the back and the cooler of goodies in the cabin.
__________________
Abby-someone
Abby-someone
12-01-2004 | 06:46 AM
#39
Registered
Joined: Dec 2003
Posts: 1,113
Likes: 0
From: Slidell,La
Re: where are the active thunder guys
Originally Posted by tomtbone1993
I just happen to have butterfly hatches 
I have been thinking about it for a while. how does it hold when being used
I have been thinking about it for a while. how does it hold when being used so it can't pull up.it creates quite a stir at poker runs & parties!!!
12-01-2004 | 08:02 PM
#40
Registered
Joined: Sep 2003
Posts: 15,491
Likes: 5
From: LAKE CONROE, TX
Re: where are the active thunder guys
Originally Posted by vette131
its very stable. we built a plate with a hole in it that is through bolted to the cross brace that the hatches rest on when closed. it also has a pin that secures it to the bottom cup
so it can't pull up.it creates quite a stir at poker runs & parties!!!
so it can't pull up.it creates quite a stir at poker runs & parties!!!
if you get a chance I would like to see a picture. My problem would be my drive shaft and
my third motor being in the way
