Harper220

I ordered two low profile hatch scoops for my 28 Daytona. Does anyone have any close-up pictures of their scoops on top and under the hatch? I'm having a local guy glass them in and cut the holes and another guy doing the vinal. Trying to figure out how to attach the vinal around scoops to keep it clean. Also looking for correct positioning and measurements? Any other helpful pointers would be appreciated... Thanks

stecz20

here are a few...

KNOT-RIGHT

I bought these from Summit 179.00 each. (Harwoods)
I reinforced them with some more fiberglass.
Painted to match then cut the holes out. and thru bolted
under the mirror on the underside of the hatch.
Didn't need to glass in because the vinyl hides it all.
I tackled all but the vinyl. I cant sew. I keep stabbing my finger
with the needle.

mcraymond3

Stecz,
How come all of your pics are Cigarettes?

Harper220

Mine will be covered with vinal and cushion too. Does that mean glassing is unnecessary? I would think so, but not sure? The guy at CP said these are glass-in style scoops. Here's the ones I ordered. Anybody know if these can be through-bolted? Still looking for very close-up pics of top and underside.

http://www.cpperformance.com/detail.aspx?ID=943

Hot Duck

Our Apache has Harwood scoops that are bolted/screwed in place with the top side surrounded by vinyl. I can take some new pictures tomorrow if you need a tighter close up or if you need a specific angle. Just let me know.

Hot Duck

Here are the same pictures blown up a bit. These got fuzzy when I blew them up, but I can take some clear close up shots tomorrow if you still need them.

Harper220

Thanks Hot Duck, those look nice. I'm still wondering if the ones that I ordered can be thru-bolted? That sounds much easier and cheaper than glassing. They would need to have a lip to thru-bolt. I guess I won't know till I get them.

GLH

Might give you ideas... hope this helps.

stecz20

what other boats are there....