Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   Particles in Bravo 1 Drive Oil ? (https://www.offshoreonly.com/forums/general-q/104243-particles-bravo-1-drive-oil.html)

Dusty Times 05-27-2005 11:39 AM

Particles in Bravo 1 Drive Oil ?
 
What is permitible for particles in Bravo 1 drive fluid?

Must be brass because not much is magnetic or holding to the magnetic plug.

Dusty Times 05-27-2005 03:13 PM

Re: Particles in Bravo 1 Drive Oil ?
 
These are pre XR drives. I'm just changing the fluid and wanting to make sure everything is OK. Don't want to wait till it self destructs.

Strip Poker 388 05-27-2005 06:03 PM

Re: Particles in Bravo 1 Drive Oil ?
 
Sounds like clutch cone[race] material in the forward or reverse gear.

Dusty Times 05-27-2005 11:11 PM

Re: Particles in Bravo 1 Drive Oil ?
 
It was just a very fine amount. I was assuming from the cluthes also but wasn't sure how much was normal.

Strip Poker 388 05-27-2005 11:28 PM

Re: Particles in Bravo 1 Drive Oil ?
 
What hp motors do ya have ?

My Scarab with 828hp did not have any in it .One of The BMax's on the Hustler does .

Mr Gadgets 05-28-2005 12:50 AM

Re: Particles in Bravo 1 Drive Oil ?
 
Dusty, the brass comes from the rings on the gears that wear on the shift fork. Not too harmful, but change your oil more often. If you see fuzz on the magnet, then wear is evident. If you feel chunks on the lower magnet the lower gears are done! If you feel chunks on the upper magnet you already are too late!! Just my experience..

Dick

Dusty Times 05-28-2005 11:29 AM

Re: Particles in Bravo 1 Drive Oil ?
 
Thanks,
They are 500 efi's in a 38' Donzi. It was very minimal (had to look twice to even notice) but I'm pretty anal and always want to make sure everything is ok.

25 hors la loi 07-13-2008 08:42 PM


Originally Posted by Mr Gadgets (Post 1342055)
If you feel chunks on the lower magnet the lower gears are done! Just my experience..

Dick

20 hrs Dick , and i found chunks on the lower magnet :( , i will post picture tomorow morning , do you think my upper is ok ? , because the magnet there are fine (no chunky there)
Thanks
Christian

Mr Gadgets 07-13-2008 11:06 PM

Any time you get metal particles on the magnet, it means they are traveling through the preloaded tappered bearings and causing some damage. How much is hard to tell without disassembling them and checking. When preload goes away due to wear, then lash gets loose and things start to break.
Like I say, it is hard to tell without looking, but I have know people to washout the upper with mineral spirits and run it. How much power are you running and what kind of prop? Seems merc is making things weaker now a days.. Not the first set of lower gears that give up after 20hrs.

Lets see some pics..

Dick

racesdad 07-13-2008 11:25 PM

you should be fine. when i was with donzi we changed gear lube every 2 races to be safe. normal wear, always keep an eye on them though


All times are GMT -5. The time now is 01:42 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.