Offshoreonly.com - Advise, Is This Cam To Big?

Page 2 of 2

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - Advise, Is This Cam To Big? (https://www.offshoreonly.com/forums/general-q/104967-advise-cam-big.html)

1BIGJIM

06-11-2005 03:03 PM

Re: Advise, Is This Cam To Big?

Don't forget the hoses also :eek: I just went to a company in town that makes them. Only cost $30 for all three.

Wobble

06-11-2005 05:20 PM

Re: Advise, Is This Cam To Big?

Quote:

Originally Posted by 1BIGJIM

How do you clean an oil cleaner after a spun bearing? That's what I thought I did and wiped out another engine. I cut the old one open this week, I don't see how you could take one apart and clean it. Bought a new one for $200 at the dealer.
JIM

Any more comments on that cam?

I wouldn't trust even a new oil cooler cooler. I run my oil filter after the cooler.

robyw1

06-11-2005 10:28 PM

Re: Advise, Is This Cam To Big?

Quote:

Originally Posted by 1BIGJIM

I just wiped out an engine with 10 hours because I was not smart enough to change the oil cooler from a previous spun bearing :mad:

OH NO

Sand Paper
Roby

Steve Snider

06-12-2005 06:47 PM

Re: Advise, Is This Cam To Big?

Over 225 duration results in reversion. Use only long stainless risers to inject the water into the exhaust stream at a further point aft. No problem with the cam if you have long risers.

All times are GMT -5. The time now is 02:32 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page