ignition problem
hi,
i bought a set of ss comp guages last week and installed them today boat is a 87 baja sport 240 merc 454 problem,when i changed the guages now the boat won't start. no spark manual says to check for batt volt at + side of the coil. i've got 1.2v???? it says if no voltage check wiring. any idea why 1.2 volts?? there are 2 purple(ign) wires that were connected to old guages. 1 has 12.5 volts(small connector org,prpl,& blk wires) 1 comes from the harness (1.2 volts) any ideas?? thanks :confused: |
Re: ignition problem
Check to make sure you didn't pull any wires off the ignition switch or maybe blew a fuse. Start with all the easy things first...
|
Re: ignition problem
i just got the boat,on the dash are breakers.does the merc wiring harness have any other fuses??
where would they be?>? |
Re: ignition problem
chaces are you didnt re-install one of the ignition leads.
should be as follows: red into ignition switch purple ou to merc harness, and to guages maybe you missed a jumper |
Re: ignition problem
thanks i need to look it over again
tried to label each gauge as i took the old ones out. never touched the key,but i must have missed something |
Re: ignition problem
check purple wire that s what supply's coil
|
Re: ignition problem
thanks for all the help,everyone :D
missed one wire :rolleyes: |
All times are GMT -5. The time now is 02:49 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.