![]() |
how much water pressure are you running?
pls let me knopw how much water perss you are running at idle speed , a good cruise, and wfo. thx, ratman
|
Re: how much water pressure are you running?
idle.........less than 5
cruise.....about 20 WOT......about 25 Carbed 540 |
Re: how much water pressure are you running?
I'm running twin 500 HP Carbed. The water pressure shows 0 when idle, 10-12 cruising, and about 15 with wot. 32 fountain. Is this normal?
Water temp stays low. |
Re: how much water pressure are you running?
Idle-2psi
3500-15psi WFO-25psi Using a crossover on a Merlin block, Merlin head 540. Twin engine 29 Fountain, no steps. |
Re: how much water pressure are you running?
Originally Posted by 32Fever97
I'm running twin 500 HP Carbed. The water pressure shows 0 when idle, 10-12 cruising, and about 15 with wot. 32 fountain. Is this normal?
Water temp stays low. |
Re: how much water pressure are you running?
baja36, do you think I should worry about such low readings? I just had both impellers / seapumps replaced. Boat has ran perfect since I bought it about 3 months ago.
|
Re: how much water pressure are you running?
idle less than 5
cruise 14-18 WOT 22 I have a similar setup to you, crossover, no t-stat, raw water pump, and a through hull water p/u. I grinded the through hull p/u down until the water pressure dropped to 15ibs cruise. I also added a pressure relief valve off my sea strainer that dumps water over board at 22psi. Water temp stays at 130* unless I clog the sea strainer. Works like a charm. |
Re: how much water pressure are you running?
b/4 or after I installed the water pressure relief valves...BZ
|
Re: how much water pressure are you running?
Originally Posted by 32Fever97
baja36, do you think I should worry about such low readings? I just had both impellers / seapumps replaced. Boat has ran perfect since I bought it about 3 months ago.
Your h2o pressure is fine. Mine is almost the same and has been for 220 hrs without any problems. It did drop a couple lbs when I changed from Gils to CMI exhaust. |
Re: how much water pressure are you running?
I dont have water pressure gauges. is it something i should add?
|
| All times are GMT -5. The time now is 02:21 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.