|
Re: Programmable knock control systems
GPM:
It's a knock control ignition. It doesn't care about the kind of fuel system. Consider using it, even if you have a laptop programmable ECU, like these Porsche tuners did with a Motec: http://forums.pelicanparts.com/showt...6s#post1998268 http://www.efi101.com/forum/viewtopi...light=j+s#7015 |
Re: Programmable knock control systems
Originally Posted by CcanDo
WE have two new engines in the dyno room now.They make 1,000 HP on 92 octane,non inter cooled.The supercharger is under driven 18% , F/A ratio is 12:1 at 6,000 , boost is 6.2 and timing is phased @31 degrees.However,we would like to start adding timing some where around 3,000 rpm.Whereas,the system is closed loop,it may be capable of adding that advance curve along with the other features.Yesterday,we looked at the crane HI-6.However,it doesn't offer some the features J&S claims,especially closed loop and individual cylinder control.My biggest concern is electronics cross talk and EMI and RFI----------------any comments will be appreciated!!!!
|
Re: Programmable knock control systems
GPM,we have not done anything yet.Next week we will get more information on the crane HI-6 and Anson combination.I still like the J&S system.I'll let you know what we do and how it works.
|
Re: Programmable knock control systems
Originally Posted by CcanDo
GPM,we have not done anything yet.Next week we will get more information on the crane HI-6 and Anson combination.I still like the J&S system.I'll let you know what we do and how it works.
|
Re: Programmable knock control systems
GPM/John,Today,I realized we have 6 each Anson Knock sensors in inventory.That sensor is plug and play with the crane HI6M.Therefore,we did order two HI6M's.But, my associate was to have tried ordering a J&S system also.I've been in meetings and not heard regarding the J&S order status.Once we would have both systems we will compare dyno pulls using one and then the other.
|
Re: Programmable knock control systems
Originally Posted by CcanDo
GPM/John,Today,I realized we have 6 each Anson Knock sensors in inventory.That sensor is plug and play with the crane HI6M.Therefore,we did order two HI6M's.But, my associate was to have tried ordering a J&S system also.I've been in meetings and not heard regarding the J&S order status.Once we would have both systems we will compare dyno pulls using one and then the other.
|
Re: Programmable knock control systems
Ccan Do...6 in stock...I have 2 Crane HI-6Ms using them on my motors, which are also on the dyno. HP500's N/A with new heads and cams. How much do you retail the Anson units for. Don't think I'll need the knock sensors, but have the ability to use them.
Let me know, Thanks Dave |
Re: Programmable knock control systems
We have been trying to reach Anson for two days to verify production.As soon as we talk with them, I'll let you know.
|
Re: Programmable knock control systems
Ccando, how does the Anson product compare to the J&S?
|
Re: Programmable knock control systems
We don't know yet.
|
| All times are GMT -5. The time now is 03:47 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.