Bent Pushrod, what caused it?
#14
Registered
VIP Member
Re: Bent Pushrod, what caused it?
Was there any rust in the exhaust ports? Everytime I've had stuff like this happen it was water coming back after the engine is shut-off from a leaking riser gasket and the valve stem rusted.
#15
Re: Bent Pushrod, what caused it?
YUP ! motor may have gotten hot , slightly had reversion, or gasket/manifold/riser failure. I've seen this on several motors. Usually freed up and worked fine with new pushrods. This happens to boats that sit along time too. BBB
Thread
Thread Starter
Forum
Replies
Last Post
Uncle Toys
General Boating Discussion
28
08-05-2002 01:42 PM