Looking for B&M 250 upper pulley's
#1
Registered
Thread Starter
Looking for B&M 250 upper pulley's
I am looking for two B&M 250 16 rib upper pulley's. The part number is 155193. The pulley diameter is 3.34".
Let me know if you have any, and if you would like to sell them.
Thanks.
Let me know if you have any, and if you would like to sell them.
Thanks.
#2
Charter Member #655
Charter Member
Re: Looking for B&M 250 upper pulley's
PM Crazyhorse he has a couple different sets for his not sure of the diameter.
__________________
If your boat has a sail do you ride a horse to the ramp?
If your boat has a sail do you ride a horse to the ramp?
#3
Registered
Join Date: Nov 2004
Location: wolfeboro nh
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Re: Looking for B&M 250 upper pulley's
call holley tech blower div. I looked into having a couple made by an outside vendor and found out that is was going to be about $300 just to spline them. turning outside was no problem but then they have to hardend. I begged holley and they made a few. Don't waste to much time calling around . Nickerson, blower shop, didn't have them. When you call Holley ask for Shane Weckerly he helped me out.. good luck
#5
Registered
Thread Starter
Re: Looking for B&M 250 upper pulley's
38TG,
I read your response on another blower post. You said you are running 6.5 lbs. with a B&M 250. Which pulley's are you running, and what CI engines do you have?
Thanks,
Greg
I read your response on another blower post. You said you are running 6.5 lbs. with a B&M 250. Which pulley's are you running, and what CI engines do you have?
Thanks,
Greg