Jerry, how did you do?
With them just as is Im running at 12psi with bumps to 15psi....the water was 2-4's... so a smooth water run/test is still set for Wed.

Mine were right at 20 psi max with the new springs, uncut. 1 motor will run a bit higher pressure until the valve is fully open, then it matches the other motor. I think my t-stat may be part of that condition. I cut 1 coil off 1 of the springs, but never ran it yet, just to see what happens. 1of the dump hose has a fast pulsating to it. The other is smooth, perfect.
All in all, I'm good to go with them uncut. What a huge relief this is. No more 50psi pressure. Down side is, I ran thru alot of gas Sat, now that I can run.

Yeah, Same here...

To the top for Easyrider