Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   hydro locked ? (https://www.offshoreonly.com/forums/general-q/126484-hydro-locked.html)

PatriYacht 04-06-2006 06:43 AM

Re: hydro locked ?
 
Where do you boat? Up here in the spring it's still cold and the water temp is in the 40's. We get a lot of steam just from the difference in temp.

boatman747 04-06-2006 10:10 AM

Re: hydro locked ?
 
I am in VA Beach . Yes so do we but one motor steams and the other doesnt. Im checking for some kind of water blockage or restriction in the motor in question now. If it was water temp problem they both would be steaming. Agree ?

PatriYacht 04-06-2006 12:16 PM

Re: hydro locked ?
 
Yes. What are your water temps at higher rpm's? If you are restricted in one engine, I would expect to see higher temps in that engine.

drewwilliams 04-07-2006 01:09 PM

Re: hydro locked ?
 
Pulled all 8 sparkplugs . One plug was super clean ? # 5

PatriYacht 04-07-2006 03:13 PM

Re: hydro locked ?
 
Your boat or Boatmans?

offthefront 04-07-2006 10:30 PM

Re: hydro locked ?
 

Originally Posted by drewwilliams
Pulled all 8 sparkplugs . One plug was super clean ? # 5

thats where the leak is ..... the water/steam cleans the plug .....a leak in that cylinder

GOODT 04-07-2006 10:40 PM

Re: hydro locked ?
 
if you want give me a call will tell / suggest what to do next...Sorry long day ( spring in the boat ind )

Joe

drewwilliams 04-08-2006 02:59 PM

Re: hydro locked ?
 
Pulling the blower off tomorrow and removing head. Going to try to remove head with out removing the motor if possible. Aluminum heads , more than likely leaking around valve guide. .

drewwilliams 05-04-2006 05:30 PM

Re: hydro locked ?
 
Ok , i pu;;ed the head had it checked , no leaks existed. Reassembled the motor with new manifolds and new risers . GIls. with 3 inch rise and aaaaaan eddie marine s pipe on the other end to get under Fountain swim platform . Motor runs fine but steams its butt off.Both motors steam pretty good now with this setup. Could the S pipes be the issue. To much restriction. I also have a little green foam in my valve cover s , only on the motor I tore down . Im thinking an Intake gasket leak. Still steams like crazy . Both motors steam hard.Maybe this set up is just going to steam until I get in the river.It might need alot of water ? Thats not available on a hose ?


All times are GMT -5. The time now is 01:52 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.