RazorsEdge

I need some advise.
I Have Livorsi Standard single controls and I purchased the clamp on single trim switch. Their does not seem to be enough room to run the wires through the throttle without it catching on something and wearing the sheathing. Any ideas or suggestions on where to run the wires?

Thanks,

Wobble

mine run down the back of the lever and then around to the leading edge where it goes though the console, i used the smallest tie wraps (color matched). Underneath I left some slack for the lever to move and tie-wrapped it so that it formed a small half loop. Just check it for a while to make sure it stays where you put it.