Offshoreonly.com - coil question

Page 2 of 2

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - coil question (https://www.offshoreonly.com/forums/general-q/132460-coil-question.html)

nordic95

06-12-2006 01:11 PM

Re: coil question

I had a stock tb 4 when I dynoed the engines.I ran the marine MSD coils with those distrb. and it worked great.I then change out the ditribs for the MSD ones and used the same coil with them.No ballast resister on either system.

vandeano

06-12-2006 06:44 PM

Re: coil question

Quote:

Originally Posted by Iggy

If I was to use this with the stock Thunderbolt IV set up will a ballast resistor be necessary??

I have been running the MSD coil with out resistor on a thunderbolt IV with no problems.

z.zuperboat

06-12-2006 08:50 PM

Re: coil question

I Have Another Problem, Can You Lay The Coil On Its Side? Out For My First Run Today And Turned The Motor Of To Check Everything Only To Findout Now No Spark On A Restart. 20 Minutes Later She Gets Spark And Runs Only To Do It Again After A Shut Down To Check To See If It Will Restart And Again No Spark? What Gives? Called Msd And They Advised To Stand The Coil Up If Its An Oil Filled Coil. Possible Thunderbolt Module Trouble ?

All times are GMT -5. The time now is 01:52 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page