Measuring For Tail Pipe Question
06-17-2006 | 05:07 AM
#1
Thread Starter
Platinum Member
Joined: Nov 2002
Posts: 2,399
Likes: 1
From: LONG ISLAND/LAKE MURRAY
Measuring For Tail Pipe Question
If I measure for one side would it be the same dimensions for the other ?
Also, currently have Merlin heads changing over to Dart. Would this effect anything ?
Also, currently have Merlin heads changing over to Dart. Would this effect anything ?
06-17-2006 | 06:05 AM
#2
Registered
Joined: Jul 2002
Posts: 2,867
Likes: 3
From: Waterford,MI
Re: Measuring For Tail Pipe Question
Not sure how you are measuring but exhausts are diferent lengths r to l. Look at the top of your engine. One cylinder head is farther back than the other. As for cylinder head differences, some have raised exhausts. .600 is common. It's enough to cause problems sometimes.
Last edited by PatriYacht; 06-17-2006 at 06:07 AM.
06-17-2006 | 11:20 AM
#3
Registered
Joined: Nov 2004
Posts: 266
Likes: 0
From: Palm Coast, FL
Re: Measuring For Tail Pipe Question
Also the holes in the transom are not always in the correct location. It would be best to measure both sides and save yourself a lot of headaches if you're having custom tailpipes built.
