drive engage question
#11
Registered
Join Date: May 2002
Location: North of the Border
Posts: 860
Likes: 0
Received 0 Likes
on
0 Posts
Re: drive engage question
Originally Posted by mats
Did you check the shift cable cladding between the transom and the drive? The cable pushes into forward gear and if the cladding is worn it becomes difficult or impossible get it into forward gear.
Have you ever seen this kind of trouble ???....i hope mine have this kind of trouble ....i will check the next spring .....
#12
Registered
Join Date: Oct 2002
Location: Stockholm, Sweden
Posts: 379
Likes: 0
Received 0 Likes
on
0 Posts
Re: drive engage question
Have you ever seen this kind of trouble ???....i hope mine have this kind of trouble ....i will check the next spring .....
#13
Registered
Join Date: May 2002
Location: North of the Border
Posts: 860
Likes: 0
Received 0 Likes
on
0 Posts
Re: drive engage question
Originally Posted by mats
Well, it happened to me and I have seen quite a few posts about it. Good luck.
Thank`s to take time
Best Regard`s
#14
Registered
Join Date: Oct 2002
Location: Stockholm, Sweden
Posts: 379
Likes: 0
Received 0 Likes
on
0 Posts
Re: drive engage question
I actally paid a Mercury shop to do it. I think I paid the shop 200 USD for doing it. That included lifting the boat (I have it in the water all summer season), the shift cable + work. The price indicates it is quite a simple procedure but it may be worth to pay someone to do it. If you have the boat out of the water you can easily check if the cladding is worn/ broken by timming the drive all the way up in trailering position and have a look. Apart from the shift cable cladding I would also check the shift cable adjustments on the engine before assuming that it is the clutch. From all the posts I have read I think the clutch is one of the few things that does not break in that drive
Good luck!
Good luck!
#15
Registered
Join Date: May 2002
Location: North of the Border
Posts: 860
Likes: 0
Received 0 Likes
on
0 Posts
Ok i check mine this past week-end ...and it`s look to be not the same linkage i have found in the manuel ....anyone know how to adjuste this one ?? ... just to be sure to do the right thing
Thank`s for any input
Thank`s for any input
#17
Registered
Join Date: May 2002
Location: North of the Border
Posts: 860
Likes: 0
Received 0 Likes
on
0 Posts