Bravo Alignment Tool
#13
Re: Bravo Alignment Tool
Yes, the ITS tool can be used on both and can help "visualize" the alignment. You can tell which direction the alignment is off by sliding the internal shaft into the coupler and leaving out the outer slide, look at the clearances between the shaft and the bearing while moving the engine.
#15
Re: Bravo Alignment Tool
heres a dim drawing of the tool for both Alpha and bravo.....i got this off of here some time ago..made a few and they work just fine....i also included an update for the alpha side if you need it for the genII drives...
__________________
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
#18
Registered
Join Date: May 2002
Location: North of the Border
Posts: 860
Likes: 0
Received 0 Likes
on
0 Posts
Ok every thing is Ok ....suppose to check alignement this week-end ....Thank`s for the mesurement ....hope i going to not have to much trouble to align the big Block
#19
Are we having fun, yet?
Charter Member
Join Date: Mar 2001
Location: Chesterfield, Va.
Posts: 782
Likes: 0
Received 0 Likes
on
0 Posts
Hey 25, is that a drive stand in the photo of the finished alignment tool? If so, can you post a picture of it assembled?
I have built two different ones. Both work ok, but I would like to make them more user friendly.
[email protected]
I have built two different ones. Both work ok, but I would like to make them more user friendly.
[email protected]
__________________
Jay
Jay
#20
Registered
Join Date: May 2002
Location: North of the Border
Posts: 860
Likes: 0
Received 0 Likes
on
0 Posts