|
Re: MSD Ignition ....
Originally Posted by offthefront
(Post 2010297)
I had planned on using my TB IV setup but there is no rev limit ...that worries me ...Also the distributor is 18 years old .... My HP is about 2x and a busted drive could be diaster without a rev Limit ..
|
Re: MSD Ignition ....
Originally Posted by the duke
(Post 2010441)
If you like tempting fate with a non marine approved Distributor. At this time, Crane does not have a marine approved one. Kiss your insurance goodbye.
Insurance ? |
Re: MSD Ignition ....
Originally Posted by the duke
(Post 2010444)
The MSD box has a REV limited built into it that can be set with different chips where ever you want it.
Duke, How the hell are you ?? Have you been wearing your new T-shirt around much ?? I havent seen you post much lately ,just wanted to say hey |
Re: MSD Ignition ....
Originally Posted by otis311
(Post 2010480)
Duke, How the hell are you ?? Have you been wearing your new T-shirt around much ?? I havent seen you post much lately ,just wanted to say hey
Its snowmobile season. or, just stay in tech, and you can see me a lot. |
Re: MSD Ignition ....
Originally Posted by offthefront
(Post 2010471)
Insurance ?
Then I change it to say kiss your boat goodby if God forbid you get a fuel leak and a spark from the non marine Dist. |
Re: MSD Ignition ....
Originally Posted by offthefront
(Post 2010297)
I had planned on using my TB IV setup but there is no rev limit ...that worries me ...Also the distributor is 18 years old .... My HP is about 2x and a busted drive could be diaster without a rev Limit ..
I highly doubt you will find any 18 year old MSD ditributors out there. I would buy a new TB IV distributor($250) for less than an MSD and run a Crane Box with built in curves and built in adjustable rev limiter. |
Re: MSD Ignition ....
I have used the crane HI-6M for two years now - the curves are for marine applications and there is enough to choose from - Box also has programable rve settings built in - It is unususal but you will have to take Merc distributor out and re-index the shutter wheel - it is not hard to do but it has to be canged - takes about 15 minutes to redrill and reset the unit - Crane SUCKS when it comes to support on other features such as knock sensors - Just got a back up unit last night - Summit
$ 303.00 |
| All times are GMT -5. The time now is 08:22 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.