Re: Ignition systems
 

I have Wallys old boat now and I am still runing the same MSD boxes with the adjustable rev limiter that he put on it I think. I am keeping thoughs boxes on there with the new 502 MPIs

Re: Ignition systems
 

I'm running the Crane box. I like the built in Rev limiter and choices of curves. The only reason I went with it was that the TB modules didn't have the advance curves I wanted. I'm keeping the stock TB module on the distributor, and wired it so that it only takes one connector change for a backup ignition system.

Re: Ignition systems
 

I have msd distributors and the Crane HI-6M boxes on my boat. No complaints here..I have had to replace a few msd boxes over the years. The Cranes are pretty cool in that you can adjust them very easily. I'm not sure if it's on every box, but mine seem to kick in about 300rpms early. Not a problem....once I became aware of it!!:rolleyes: :D

Re: Ignition systems
 

I've had enough of bad MSD components. For the past 5 years I'm running plain old Thunderbolt IV with the V-6 modules. Very simple and never let me down.

Re: Ignition systems
 

If its all still mounted on the transom behind the engines then yup! i did install all that stuff....too bad i dont have a pic of it...but heres a pic of the original engines i had in it before i sold it to my buddy....who then sold it to that guy in WA who then sold it to you....
This was durring the rigging....they havent been started yet at this point....this was after the new bilge paint...wiring...the diamond plating on the fire wall and ledge.

Re: Ignition systems
 

I run & have sold quite a few D.U.I components and have not had any problems.

Re: Ignition systems
 

Crane works very well and also lasts a long time in our punishing environment.

Thanks for the info.