Are there fitting included with KPM's strainers
#1
Registered
Thread Starter
Join Date: Jul 2004
Location: Stockholm, Sweden
Posts: 1,229
Likes: 0
Received 0 Likes
on
0 Posts
Are there fittings included with KPM's strainers
Just ordered a 8" sea strainer and a intercooler strainer but since KPM's website is down I cannot decide wether the fittings are included and what size the threads are in the strainers.
Anyone know?!
Anyone know?!
Last edited by tomas_wallin; 03-05-2007 at 05:15 AM.
#2
Registered
Platinum Member
THey will be pipe threads commonly. Either 1" or 1.5". Use only brass or copper. Best to get from a plmbing suply house or boat rigger. Home depot and Lowes stuff is sometimes flawed and will give you a headache. I don't know if those come with fittings, but I've never seen sea strainers come with accesories. Usually mounting bracket nd housing.
#7
Registered
My mistake. The KPM intercooler strainer was 3/4" pipe, and the water pump was 1" pipe. I don't know about the sea strainer, but I'd have to assume its 1" since the water pumps are 1"
Keep in mind, kpm made several changes to all these parts over time. From my experience, you can't be 100% sure with them until the part arrives.
Keep in mind, kpm made several changes to all these parts over time. From my experience, you can't be 100% sure with them until the part arrives.
Thread
Thread Starter
Forum
Replies
Last Post
point92mach
General Q & A
3
07-05-2007 07:17 AM