Can someone give me the measurement from the transom (inner transom plate) to crank pully? End to end measurement on a big block Bravo setup, thanks.

not me, sorry... just bringing your tread back up on top!

what are trying to figure ? you asking centerline from the rear mounts to the crank pully ? about 35"

I'm trying to figure how long a big block chevy is from end to end on a Bravo setup. Say if you look in your bilge at your motor. From the crank pully to the transom? So if you say 35" from crank pully to rear mounts...add the rest of the transom plate. 4" or 5" inches? Whats the total end to end?

Thanks
John

sounds about right ... I'll try to get you a measurment ...

Thanks...I'm trying to see how far back I can put my rear bulkhead. I don't want to run into any problems when setting the motor back in...like my crank pulley resting on my bulkhead

40" ..from the transom to the crank pulley ...about centerline of the exhaust ....m

Thanks