water pressure sending unit 496
#1
Crazy Energy
Platinum Member
Thread Starter
iTrader: (4)
Join Date: Aug 2007
Location: Oklahoma God's country no one else wants it.
Posts: 4,334
Likes: 0
Received 1 Like
on
1 Post
water pressure sending unit 496
2003 496 where is the best place to put the sending unit on my 496 for water pressure gauge? Thanks K.C.
#2
Registered
Join Date: Feb 2005
Location: long island, newyork
Posts: 2,551
Likes: 0
Received 2 Likes
on
2 Posts
therer is a bung allready on the oil cooler on the back of the engine used for a water pressure sender for the smart craft and computer monitoring.. remove the factory unit and install a 1/4 pipe male,male, female tee.
#6
Rough Seas Lie Ahead
Gold Member
Join Date: Feb 2002
Location: Virginia Beach, VA
Posts: 2,465
Likes: 0
Received 0 Likes
on
0 Posts
Typically they come stock with a splitter off the brass T on the raw water pump where the smartcraft sending unit is, at least on my 2005.
#8
Registered
iTrader: (2)
no I'm asking if you have two 3 1/2" gauges you could remove and replace them with smartcraft sc1000's or if you have room to install an sc5000 system view. I have the ones I took out of my daytona and I was very pleased with the information they provided, much better than analog gauges.
#9
Crazy Energy
Platinum Member
Thread Starter
iTrader: (4)
Join Date: Aug 2007
Location: Oklahoma God's country no one else wants it.
Posts: 4,334
Likes: 0
Received 1 Like
on
1 Post
no I'm asking if you have two 3 1/2" gauges you could remove and replace them with smartcraft sc1000's or if you have room to install an sc5000 system view. I have the ones I took out of my daytona and I was very pleased with the information they provided, much better than analog gauges.