Need help from some motor guru's
#1
Registered
Thread Starter
Join Date: Jul 2005
Location: evansville In
Posts: 482
Likes: 0
Received 0 Likes
on
0 Posts
Need help from some motor guru's
Hey guys, Did they make a two piece rear main 502 block? I was looking at a 540 and it has a 2 piece seal and I haven't seen one with that seal.? Would there be another way to get a 540 out of another block? I think the back of the block has MARK IV cast into it, But is hard to see. Thanks
#4
Registered
Join Date: Apr 2006
Location: HUNTINGTON BEACH, CA.
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
I had mark 4 502 s in my old boat and they had the bow tie on the side of the nlock. So yes there are mark 4 two piece seal 502 blocks out there they were mad between 1988 and about 1991 so good luck finding them.
#9
#10
Registered
Thread Starter
Join Date: Jul 2005
Location: evansville In
Posts: 482
Likes: 0
Received 0 Likes
on
0 Posts
Further search of the block did reveal a 8.2 casting, But no bow tie. A guy has a 540 all fresh with NEW edelbrock heads,all roller for 6800. Just checking some info I wasn't sure about. ........AUH, yes I read that thread p..bull..HA HA HA