Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   Help, Trim Tab Wiring (https://www.offshoreonly.com/forums/general-q/191088-help-trim-tab-wiring.html)

bleachers 07-15-2008 06:57 AM

Help, Trim Tab Wiring
 
It has been so long since i removed my engines from my 38 sonic that in reinstalling, i have forgotten were the long red wire coming off the oump for the tabs goes. it is long enough that i beleive it goes to starter solenoid, just wondering if anyone knows for sure

Wally 07-15-2008 08:32 AM

That red wire needs 12V+ batt power....if its long enough to reach the starter then connect it to the batt cable...if you can go straight to the battery, even better.....or if you want to be able to have the batt's isolated when the boats not in use, run the red wire to the output of your 1/2/both switch.....

PatriYacht 07-15-2008 09:12 AM

Mine goes to the starter positive where the battery cable attaches. My pump has a circuit breaker on it.

bleachers 07-15-2008 10:15 AM

thanks, i thought that is were it went, to the starter, does it go on the same side of the solenoid as the little starter wire on on the other small pole?-- i have so much to reassemble that i am getting brain freezes

jhiguy377 07-15-2008 11:18 AM


Originally Posted by bleachers (Post 2623894)
thanks, i thought that is were it went, to the starter, does it go on the same side of the solenoid as the little starter wire on on the other small pole?-- i have so much to reassemble that i am getting brain freezes

No, I believe that wire is energized only when you engage the starter. You really want the trim pump to have continuously available power whenever your safety main switch(es) are on. Good luck- Jeff


All times are GMT -5. The time now is 07:44 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.