Originally Posted by Bryan Rose (Post 2633479)

For any one that needs any kind of computer tuning or HP stuff this is your place. I recently did some upgrades to my 500 EFI , Blower, Aluminum Heads, etc...and it needed some fine tuning to get it right, I sent the ECU down , Mark got it very close the first time but he told me the best way was to tune it in the boat. Well I made the 500 mile trip, keep in mind thaat is each way, and it is now dead on perfect. He and the guys down there run a first class operation, great shop, great hardware and all around just a great bunch of guys. A lot of people think they are EFI guru's but Mark can back it up, when the time comes to build a big EFI Motor this is where I am going.

Hey Mark, fun running in the canal for sure but next time once I have the big tabs on my boat we can run out in the lake. Kind of a strange experience running over 85 in a canal maybe 100 ft wide and only 6 feet deep.....


Thank you!

Bryan

Originally Posted by Whipple Charged (Post 2634029)

Mark and the guys at Precision Marine are one of our #1 dealers and I highly recommend them! He's one of the best in the industry.

Dustin

Originally Posted by CAL MAN (Post 2634176)

Thanks everyone, and Dustin, you know its all about good applesauce.

Thanks
Mark

Originally Posted by Whipple Charged (Post 2634029)

Mark and the guys at Precision Marine are one of our #1 dealers and I highly recommend them! He's one of the best in the industry.

Dustin

Originally Posted by CAL MAN (Post 2634176)

applesauce.

Originally Posted by Dock Holiday (Post 2634791)

I hope that is what the sticky stuff on my engines is and not something else!:eek:

Originally Posted by ZXXX Donzi (Post 2633584)

It is catching on!

Heck, there are 90 mph Baja's and Fountains. I could never see why it was not done in big single Donzi's.:evilb:

After getting dusted by an 85 mph Baja last year, we all went back to the drawing board.:ernaehrung004: