Fuel pump pushrod
 

Will I be able to use a stock fuel pump rod on my steel billet camshaft? I remember reading somewhere , that maybe a stock rod would wear down the pump lobe on the cam.

Someone set me straight!!



thanks

Travis

No you can't. You need one with a special tip.

.. thanks cord..

I just found one in PAW that has a bronze tip for steel cams. It's a lightweight rod though, but this is the only one i can find





Travis

"your a 3/4's of a mile ....call the ball" :D

Use the bronze tip shaft, be sure to install the gold end into the cam. :D I'm kidding, but I've seen it purchased and installed backwards.

Now it's been a while...but I believe that your rod installation will go easier if you thread a bolt through the front of the block to gently jam it in place. Just be sure you use an appropriate length bolt later on-you'll end up with a oil leak if you leave the hole open. Too long of a bolt and...

well cord I am **** drunkand I can't even tel what the F&^@#K your talking about... man All I am going to do is ioler her up and slamit in the hole hole.. no problem shte last times LOL!

thanks man..

travis