engine coupler
 

I am looking to replace my stock coupler while the engine is out,anyone got any advice on which to buy,i have been recommended one from teaque but is going to cost )$700(canadian) but if thats what it costs thats what it costs,i need one for a big block chev about 665-670 hp.

call donnie at ofshore performance in fla. use the long nose (steel)

I like the long snout steel one as well. merc part #861523A7

http://www.mercruiserparts.com/Show_...ler+Components

Here ya go.:drink: http://www.cpperformance.com/detail.aspx?ID=682

:Whatever:Sorry but that is not the steel one from merc racing. Steel one has a long snout were the input shaft goes into the coupler they cost $100 more, but I would rather break a drive than a coupler. Coupler goes out motor has to come out.

Merc has short and long snouts in steel.

who has the best price on the long snout merc coupler, i plan to order one this week

The new part # for the long nosed steel hub coupler is 861523a20 and has a list $ of $545.00. Mercury shows (1) of these in California unless someone has them on the shelf.

We use Offshore performance in fla. they give a discount most times. 239-489-0884 ask for donnie tell him Gerald from Chattanooga said to give u a discount.:p

older thread I know , but does anybody happen to know the measurements on the short & long snout ?? Or either one of the two for that matter..

I have 2 in real good shape & I will not be needing but 1 of them so I will most likely sell the other one & I would like to make sure which ones I have..

Thanks , Scott