proper way to put boat back in the water after its winterized
01-25-2009 | 08:59 AM
#2
Banned
Joined: Oct 2006
Posts: 5,844
Likes: 0
From: Bradenton Florida
Conect all the hoses back,,,check everything, Then warm up the engine on the waterhose.
Change oil ,check drivefluid,check sparkplugs, change fuel filter.
Spray all electric stuff with WD 40,,clean the boat ,wax or polish it and go have fun.
Depends on what drive u have ,also check the gimbal bearing and the belows.
On the hose when u warm up ,make shure u check the waterlines for leaks( exhaust and sofort)
Thats what i would do.
Change oil ,check drivefluid,check sparkplugs, change fuel filter.
Spray all electric stuff with WD 40,,clean the boat ,wax or polish it and go have fun.
Depends on what drive u have ,also check the gimbal bearing and the belows.
On the hose when u warm up ,make shure u check the waterlines for leaks( exhaust and sofort)
Thats what i would do.
01-25-2009 | 08:01 PM
#3
Charter Member # 55
Joined: Oct 2000
Posts: 20,242
Likes: 2,490
From: Omaha/LOTO
I put it in the water and turn the key
You really shouldn't have to do anything special, but that can vary a little depending on who winterized it and if they disconnected some hoses. Charge the batteries and check all fluid levels. Check for leaks or water in bilge after you put it in the water and start it.
You really shouldn't have to do anything special, but that can vary a little depending on who winterized it and if they disconnected some hoses. Charge the batteries and check all fluid levels. Check for leaks or water in bilge after you put it in the water and start it.
Thread
Thread Starter
Forum
Replies
Last Post
Audiofn
General Boating Discussion
14
05-24-2004 03:14 PM
