Go Back  Offshoreonly.com > Technical > General Q & A
502 Mag Mpi Problem >

502 Mag Mpi Problem

Notices

502 Mag Mpi Problem

Old 08-15-2009, 11:25 PM
  #11  
Registered
 
Join Date: Aug 2009
Location: corona, ca
Posts: 11
Likes: 0
Received 0 Likes on 0 Posts
Default Hope this helps

ok . the thing I would check .

First the mefi controller is batch fire what happens is cly 2,8,3,5 and 1,7,4,6 fire the injectors on two circuits . both have 12v on when the ignition is on so what happens is the negitive is grounded by the computer . I have seen where the negitive side is shorted to ground and will cause the injectors to fire full open until the engine is flooded .

Second if in ruff water the engine can hits the rev limiter several times the engine will ether shut down or go into a limp mode . The delphi mefi controller have safety controls for example low oil , low voltage less than 10v can cause a lot of problems seen most of the time under high engine load . Over heating can make the engine go in to a limp mode .

Third , secondary ignition , spark plugs, plug wire , and cap and rotor , also seen most under a heavy load . seen most between 3000 and 45 hundred rpms

I hope this helps if you are in southern ca. we tune and diag a lot of mefi controller issues

chris
cbm motorsports is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


OSO Sponsor
OSO Advertiser
OSO Advertiser

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

OSO Advertiser