TRS - tilt/trim VERY slow (is this normal)?
#1
Registered
Thread Starter
Join Date: Nov 2008
Location: Houston, TX
Posts: 166
Likes: 0
Received 0 Likes
on
0 Posts
TRS - tilt/trim VERY slow (is this normal)?
I've never had a TRS drive before, so I'm not well informed about them.
It's a 1980 Excalibur w/ (I assume) original TRS drive.
The drive moves VERY slow (up and down). Is this normal?
Does the pump need servicing of some kind when it get slow like this or is there a common/known problem I should know to check?
Thank you.
It's a 1980 Excalibur w/ (I assume) original TRS drive.
The drive moves VERY slow (up and down). Is this normal?
Does the pump need servicing of some kind when it get slow like this or is there a common/known problem I should know to check?
Thank you.
#2
Registered
Join Date: Oct 2009
Location: Dayton, Ohio
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
I've never had a TRS drive before, so I'm not well informed about them.
It's a 1980 Excalibur w/ (I assume) original TRS drive.
The drive moves VERY slow (up and down). Is this normal?
Does the pump need servicing of some kind when it get slow like this or is there a common/known problem I should know to check?
Thank you.
It's a 1980 Excalibur w/ (I assume) original TRS drive.
The drive moves VERY slow (up and down). Is this normal?
Does the pump need servicing of some kind when it get slow like this or is there a common/known problem I should know to check?
Thank you.
I have the same problem, execpt one of mine moves lower than the other, I just havent looked into the cause yet.... maybe i will too feed from your question...
Thanks.
#7
Registered
iTrader: (4)
I had the same problem with my boat when I bought it. My TRS drives were somewhat slow. I tore the the trim motors apart and cleaned up any oxidation inside and around the copper coils. I replaced the worn out brushes. I got the brushes at the local alternator/starter rebuild shop. I also ran new + and - wires to my pumps. This helped considerably.
#10
Registered
Platinum Member
Join Date: May 2007
Location: Chicago, Illinois
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
I had a similar problem but I had one of my TRS drives that wouldn't go up as high as the other side. Pulled and cleaned pumps but still had the same problem. Bled the line and problem solved.