|
camshaft id
How about this one ? The only number on the camshaft is one on the backside. It is 01 96 0196 i think it is a mercuiser one but how about the specs? it is out of a 600sc Who knows ? Thx Greg
|
Fixx
Originally Posted by greg bakker
(Post 3361228)
How about this one ? The only number on the camshaft is one on the backside. It is 01 96 0196 i think it is a mercuiser one but how about the specs? it is out of a 600sc Who knows ? Thx Greg
|
I don't know the specs for the 600sc cam, but the are listed in the Merc HP3 Manual.
|
ok ,thank you
|
Greg,
Providing you can verify the lobe lift it is relatively easy to identify the camshaft. If the cam is still in the engine use a lifter and dial indicator. If out of the engine, use V blocks. The lift, on both intake and exhaust should be .329”, at the lobe. If this is correct, sent over an email and I will provide you with the cam card. To avoid any potential confusion, this is the flat tappet core, not the roller core from the 600 SCI, correct? Bob |
| All times are GMT -5. The time now is 07:48 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.